The Logo Profile dialog is used to extend the image files that have been uploaded in the Manage Image Files dialog to a logo profile with the corresponding display options.
A logo profile is the combination of an image file and its positioning information in the camera image.
Select the desired option to either activate or deactivate the logo display in the camera image.
|Note:||Click on the More button to display all options for all profiles.|
Set the following parameters in the Image Profiles dialog for each profile:
|Logo n||Enter a unique logo name. The camera will use this name for error messages.
Valid characters are letters, digits, dot, comma and underscore.
|Enable Logo||Using this switch, you can temporarily hide individual logos. Hidden logos remain stored and can be shown again later on.|
|Time Table||To show a logo time-controlled, you can select a Time Table.|
|Live Image Logo||Using this option, you define whether or not the logo is displayed in the live image.|
|Image Link Logo||Specify, whether or not the logo may be used for custom image formats. If you choose the force setting, the logo is displayed in every image and cannot be removed.|
|Image Sizes||Highlight the allowed camera resolutions that may use this logo. The logo is only displayed in the image if it has been approved for this resolution.
|Logo Opacity||Use this option to define how visible the logo is displayed within the camera image. Specifying the opacity value lower than 100% results in the actual camera image to shine through. If you would like to obtain a watermark effect, try setting the opacity to 20 to 30%.|
|Image List||The image list contains all available Image Files. You may use one or multiple image files for a logo. When selecting several image files, they are displayed one at a time (rotated) at short intervals.|
|Rotation Interval||Specify the interval for displaying the image files from the image list one at a time.|
|Positioning Mode||The logo image files can be positioned in the camera image in two different ways. For each possibility, the alignment and offset information is interpreted differently.
In order to delete a profile, check the Delete option in the top right corner of the profile. The profile will be deleted as soon as you click on the Set button in the lower part of the dialog.
Using an image file, you can draw a frame in the camera image. Make sure Positioning is set to Frame.
|Edge piece top||Corner
|Edge piece left||Unused.||Edge piece right|
|Hint:||It is recommended to create an image file with dimensions that can easily be divided by three, e.g. 90 x 90 pixels.|
The sample file shown fulfills all prerequisites to be used as a frame:
To configure this image files as frame:
35for both the X Offset and the Y Offset parameters.
Adapt the frame's Opacity as desired.
Click on the Set button to activate your settings and to save them until the next reboot of the camera.
Click on the Close button to close the dialog. While closing the dialog, the system checks the entire configuration for changes. If changes are detected, you will be asked if you would like to store the entire configuration permanently.